• When all conditions below are satisfied and 100 s or more have passed.
-
- Engine speed 530 rpm or more
-
- Vehicle speed 20 km/h {12 mph} or more
-
- Voltage at PCM terminal 1X (Z6)/1S (LF) 0.5 V or more
-
- P, R, N, or D range/position not detected
Diagnostic support note:
• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
• The PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
• FREEZE FRAME DATA is available.
• The AT warning light illuminates.
• The DTC is stored in the PCM memory.
|