AFTER REPAIR PROCEDURE [FN4A-EL]

Caution

• After repairing a malfunction, perform the following procedure to verify that the malfunction has been corrected.

• When performing this procedure, be sure to drive the vehicle at lawful speed and pay attention to the other vehicles.

1. Connect the WDS or equivalent to the DLC-2.

2. Turn the ignition switch to the ON position (engine off).

3. Verify that DTCs are cleared from memory.

4. Decrease ATF temperature to 20 °C {68 °F} or less.

5. Start the engine then wait 180 s or more.

6. Warm up the engine and ATX.

• Engine coolant temperature: 60 °C {140 °F} or more.

• Transaxle fluid temperature: 20 °C {68 °F} or more.

7. Shift the selector lever between P position to M range while depressing brake pedal.

8. Drive the vehicle for 150 s or more at a vehicle speed between 25 and 59 km/h {15 and 36 mph}, then 60 km/h {37 mph} or more for 100 s or more.

9. Drive the vehicle in D range and shift gears between 1st and 4th (TCC operation) gear.

10. Gradually slow down and stop the vehicle.

11. Make sure that the repaired DTC does not recur.