NO.7 NO VOICE NAVIGATION
B3E090366000W08
Diagnostic procedure
STEP
|
INSPECTION
|
ACTION
|
|
---|---|---|---|
1
|
• Set destination as desired.
• Press the "MENU" button.
• Select "Setup Menu".
• Select "Simulation", then carry out the simulation.
• Does the voice navigation function activate during simulation?
|
Yes
|
The system is normal.
|
No
|
Go to the next step.
|
||
2
|
• Press the "MENU" button.
• Select the "Setup Menu".
• Select the "System Setup".
• Select the "Volume", and verify the voice navigation value.
• Is the voice navigation volume at "0"?
|
Yes
|
Adjust the volume from "1" to "4", then repeat Step 1.
|
No
|
Go to the next step.
|
||
3
|
• Turn the audio power switch (CD, MD, radio) to ON.
• Does the driver-side front door speaker work?
|
Yes
|
Replace the car-navigation control unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
|
No
|
Go to the next step.
|
||
4
|
• Turn the ignition switch to the LOCK position.
• Remove the driver-side front door speaker. (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION.)
• Inspect the connection of the driver-side front door speaker connector (2-pin).
• Disconnect the driver-side front door speaker connector (2-pin).
• Inspect both the driver-side front door speaker and wiring harness-side connector for poor connection (such as damaged/pulled-out pins, corrosion).
• Are all the pins normal?
|
Yes
|
Go to the next step.
|
No
|
If poor connection of driver-side front door speaker connector:
Securely connect the driver-side front door speaker connector.
If the driver-side front door speaker side connector is wrong:
Replace the driver-side front door speaker. (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION.)
If the wiring harness-side connector is wrong:
Repair or replace the pins and/or the connector.
|
||
5
|
• Remove the car-navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
• Inspect the connection of the car-navigation unit connector (16-pin).
• Disconnect the car-navigation unit connector (16-pin).
• Inspect both the car-navigation unit and wiring harness-side connector terminal M and N for poor connection (such as damaged/pulled-out pins, corrosion).
• Are all the pins normal?
|
Yes
|
Go to the next step.
|
No
|
If poor connection of car-navigation unit connector:
Securely connect the car-navigation unit connector.
If the car-navigation unit side connector is wrong:
Replace the car-navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
If the wiring harness-side connector is wrong:
Repair or replace the pins and/or the connector.
|
||
6
|
• Inspect for continuity between car-navigation unit and the driver-side front door speaker.
• Is there continuity?
|
Yes
|
Go to the next step.
|
No
|
Repair or replace the wiring harness.
|
||
7
|
• Inspect the driver-side front door speaker. (See FRONT DOOR SPEAKER INSPECTION)
• Is it normal?
|
Yes
|
Replace the car-navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
|
No
|
Replace the driver-side front door speaker. (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION.)
|