DTC P0344 [MZ-CD 1.6 (Y6)]
B3E010200300W12
Diagnostic procedure
STEP
|
INSPECTION
|
ACTION
|
|
---|---|---|---|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
No
|
Record FREEZE FRAME DATA on repair order, then go to the next step.
|
||
2
|
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
• Verify related service bulletins and/or on-line repair information availability.
• Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to available repair information.
• If vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
3
|
VERIFY CURRENT SIGNAL STATUS: IS CONCERN INTERMITTENT OR CONSTANT?
• Connect the WDS or equivalent to the DLC-2.
• Clear the DTC from the PCM memory using the WDS or equivalent.
• Run the vehicle under the FREEZE FRAME DATA stored condition.
• Is the same DTC present?
|
Yes
|
Go to the next step.
|
No
|
Intermittent concern exists.
Perform the "INTERMITTENT CONCERNS TROUBLESHOOTING", go to the next step.
|
||
4
|
INSPECT CMP SENSOR PULSE WHEEL
• Inspect the CMP sensor pulse wheel.
• Is there any malfunction?
|
Yes
|
Inspect the CMP sensor pulse wheel for damage.
Replace the CMP sensor or CMP sensor pulse wheel, then go to the next step.
|
No
|
Go to the next step.
|
||
5
|
VERIFY TROUBLESHOOTING OF DTC P0344 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Turn the engine switch to the ON position. (Engine off).
• Clear the DTC from the PCM memory using the WDS or equivalent.
• Run the vehicle under the FREEZE FRAME DATA stored condition.
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
No
|
Go to the next step.
|
||
6
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the after repair procedure.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZ-CD 1.6 (Y6)].)
|
No
|
DTC troubleshooting completed.
|